EQP-200B Basic Operating Instructions

Filtering and EQing a single or stereo source: Plug the EQP-200 directly into the insert jack(s) on the mixing console. Put the insert send into the XLR input, and the XLR output back into the insert return of the desired channel. The EQP-200B sounds great if inserted directly after the preamp, or before or after a compressor.

Boosting or cutting a low frequency: Select which frequency needs to be boosted or cut with the low frequency select knob. To increase the bass, turn the boost knob up to the desired amount and make sure the cut knob is turned all the way down. To roll off the bass, turn the boost knob down and the cut knob up.

Boosting a mid-high frequency: Select which mid-high frequency needs to be increased. Turn up the mid-high frequency boost knob and select the proper bandwidth. A higher number on the bandwidth knob is a wider bandwidth.

Cutting a high frequency: Select which high frequency needs to be attenuated with the high frequency select knob, then turn the high frequency cut knob to the appropriate amount.

Low shelving: Set the low EQ section to shelving filter. This will engage a 6dB per octave shelving filter starting at the frequency you select.